OKTOPUS® PANEL-Jack KT-B mit DT5

kt-b-dt_5.jpg
KT-B_singel.jpg
kt-b-dt_10.jpg

For the installation of horizontal and vertical wall elements as well as for installing roof elements

Dual circuit system

2 independent vacuum circuits, each vacuum circuit with 2-fold safety and integrated reserve vacuum
for construction site use according to DIN EN 13155

Application

suitable to install roof elements with a maximum length of approx.14 m
Coupling two OKTOPUS® PANEL-Jack KT-B single devices with a roof cross beam of either 6 m or 10 m (DT 6 or DT 10) is possible. In this case roof elements of up to 22 m in length can be installed.
As a single device it is suitable for installing horizontal and vertical wall elements as well as roof elements of up to 8 m in length.

Hoist

e. g. truck-mounted crane, top slewing crane

Suspension

crane mounting horizontal installation: is needed for horizontal wall installation,
crane mounting vertical installation: is needed for vertical wall installation
roof cross beam 5 m (DT5) with adjustable chain lashing

Equipment

chain lashing
rope lashing
safety belts

Options

set of spare batteries and additional battery box to double operating time

Material to be handled
Using the tried and tested Wirth round and oval suction pads you can transport and install almost every standard sandwich element and many corrugated sheets with the OKTOPUS® PANEL-Jack KT-B. The suction areas of the elements to be lifted must be air-impermeable, have to have an even and clean surface and must not be covered with protective film.

Working Load Limit OKTOPUS® PANEL-JACK KT-B in connection with a 5 m roof cross beam

Suction pads	Max. working load limit depending on the type of suction pad and the inclination (α) of the elements to be installed 0° ≤ α ≤ 10°
8 round suction pads (∅ 250 mm)	350 kg
12 round suction pads (∅ 250 mm)	400 kg
8 oval suction pads (100 mm x 320 mm)	200 kg
12 oval suction pads (100 mm x 320 mm)	300 kg
16 oval suction pads (100 mm x 320 mm)	400 kg

Application data

Weight:	single device including DT5: approx. 230 kg
Operation:	control panel on the device
Power supply:	rechargeable battery, 24 V
Vacuum generation:	vacuum pump
Suction pads:	Wirth standard suction pads - round suction pads (ø 250 mm) or - oval suction pads (100 mm x 320 mm)
Equipment:	- crane mounting horizontal installation - crane mounting vertical installation - rope lashing (2 ropes, l = 3 m) for single device and DT 5 - chain lashing (2 chains, 2 ropes, l = 3 m) - transport box for single devices - transport palette - safety belts - protective caps for suction pads
Options:	set of spare batteries