Phone: +49 (0) 34 602 / 70 88 - 0
Phone: +49 (0) 34 602 / 70 88 - 0

OKTOPUS® PANEL-Jack IT-B

Suitable for installing wall elements horizontally, for installing ceiling elements and for turning over construction elements.

Dual circuit system

  • 2 independent vacuum circuits, each vacuum circuit with 2-fold safety and integrated reserve vacuum
  • for construction site use according to DIN EN 13155

Application

  • Suitable for installing wall elements horizontally, for installing ceiling elements and for turning over construction elements.

Hoist

  • forklift

Suspension

  • fork sleeve

Material to be handled

Using the tried and tested Wirth round and oval suction pads you can transport and install almost every standard sandwich element and many corrugated sheets with the OKTOPUS® PANEL-Jack IT-B. The suction areas of the elements to be lifted must be air-impermeable, have to have an even and clean surface and must not be covered with protective film.


  • 8 round suction pads (∅ 250 mm)max. 250 kg
    12 round suction pads (∅ 250 mm)max. 400 kg
    8 oval suction pads (100 mm x 320 mm)max. 130 kg
    12 oval suction pads (100 mm x 320 mm)max. 200 kg

  • Weightapprox. 620 kg
    Operationcontrol panel connected via cable to the device
    Power supply24 V battery
    Vacuum supplyvacuum pump
    Optionsradio remote control
    Movements
    Tilt around vertical axis (swivel)120°
    Turn over180°

Datenblatt PANEL-Jack IT-B

Legend

  • Crane attachment
  • Fork lift attachment
  • Vertical wall installation
  • Horizontal wall installation
  • Roof installation
  • Overhead installation
  • Rotate 360°
  • Tilt around horizontal axis
  • Turn-over ≥ 180°
  • Tilt around vertical axis (swivel)
  • Side stroke
  • Teleskop. Ausleger/ Kranarm/Hubsäule
  • Control panel at the device / cable remote control
  • Radio remote control
  • Manual operation
  • Battery

sandwich devices

  • construction zone
  • sandwich devices
  • OKTOPUS® PANEL-Jack IT-B (h)